Desk

A stand that fits your device

Measure the thickness with the case on, pick a lean, leave a slot for the cable. It prints flat on its side with no supports.

Starting point

Only a set of defaults — every number below is still yours to change.

Device thickness11 mm

With the case on. 0.6 mm of clearance is added for you.

Lean20° from upright

Width70 mm

Back support60 mm

Front lip12 mm

Material thickness4 mm

Extra base8 mm

Base behind the support. More is harder to tip over.

Cable slot — charge while it sits

Slot width24 mm

Make a pair — one for each end

Size: — · Sits at —

Triangles: — · Est. weight: —

Recommended: Print as exported — it lies on its side No supports 3 walls, 20% infill

Stick a few felt pads or a strip of TPU in the channel — bare PLA against a phone back scratches it.